DATAFX Battery Cell Monitor

Monitors, Displays and Prints Battery Service Reports using EPSON LX-300+ Serial Printer
(not included).

  • Compatible with RF80-K, RF80-M and U-60 charger/analyzers
  • Designed for nickel-cadmium and lead-acid batteries
  • Automatically scans nickel-cadmium batteries, acquiring real-time cell data
  • Display shows all cell voltages, battery current/voltage, and faults
  • Cells with faults flash on/off
  • Print button to print out display at any time or reprint last report
  • Documents initial, intermediate, and ending voltages for every cell
  • Documents elapsed charge or discharge time, and ampere-hours
  • Documents charge or discharge history at regular intervals
  • Graphs battery voltage for charge/discharge
  • Visual and audible warnings for fault conditions
  • Quick-connect cell probes and wiring harness support arm for easy use
  • Mounts on or under shop shelf

Mechanical:

Size: 8" (20.3cm) wide × 9" (22.9 cm) deep × 4.3 " (10.8 cm) high Net weight: 7 pounds (3.2 kg), inclusive of harness

Electrical Input:

Input Power 90 to 135 or 200-265 VAC Frequency: 50 to 60 Hertz Current Requirements: 0.03A, typical Power Switch: Opens both sides of line

Environmental (Non-Operating):

Altitude: 0 to 40,000 feet Temperature: -20 to +75 degrees C Relative Humidity: 60% maximum

Environmental (Operating):

Altitude: 0 to 40,000 feet Temperature: -20 to +75 degrees C Relative Humidity: 60% maximum